UDLB-7BA

TUNGSTEN CARBIDE SANDBLASTING NOZZLE FOR BLAST CLEANING. THIS CARBIDE SANDBLASTING NOZZLE HAS A 7/16" BORE AND IS DESIGNED TO USE VENTURI EFFECT TO INCREASE VELOCITY AND KENETIC ENERGY OF ABRASIVE PARTICLES. INCREASED ENERGY AND HIGHER EXIT VELOCITY CONTRIBUTES TO FASTER REMOVAL OF COATINGS OR CONTAMINANTS FROM SURFACE BEING BLAST CLEANED.  UDLB-7BA NOZZLE HAS AN ERGONOMIC, EASIER TO HOLD, JACKET DESIGN, MADE FROM TOUGH THERMOPLASTIC. BRASS THREADS ARE INDUSTRY STANDARD 1-1/4" NPSM . NOZZLE JACKET CONSTRUCTED USING ENGINEERING GRADE THERMOPLASTIC AND BRASS 1-1/4" FINE THREADS. THIS TOUGH NOZZLE IS USED WIDELY FOR BLAST CLEANING IN  HARSH SITE CONDITIONS. IF YOU ARE USING ALUMINUM OXIDE TO BLAST CLEAN WITH, TAKE A LOOK AT OUR EVBC-7 FITTED WITH A VERY HARD AND WEAR RESISTANT BORON CARBIDE LINER. WHY USE BRASS THREADS? THEY ARE  LESS LIKELY TO GAUL IN ALUMINUM NOZZLE HOLDERS. 

SPECIFICATIONS:

MODEL: UDLB-7BA

PART NUMBER: 926014

BORE: 7/16"

ENTRY: 1"

LENGTH: 7.75"

REPLACEMENT WASHER: NW-1514

USES NOZZLE WASHER NW-1514